RCA Voyager 7" Screen Replacement

Hey guys, I'm back with another breakdown, but this time its of a tablet.  Today I got in a RCA Voyager 7" tablet with a cracked screen.  Luckily this time it wasn't the LED, it was just a digitizer which, is the glass part over the devices LCD screen, that causes it to be touch screen.  They are much cheaper! 

For this set up all your going to need is a small Phillips head and a small pry tool.

You will see two holes on each end where I already removed the Philips screws.



After you remove them screw, use the pry tool to pry the back from the front, just be careful because the speaker will be connected to the back plate but the wires will be soldered to the board on the front half.

First around the orange circles there are ribbon connectors there that need to be disconnected.  Then at the bottom of the circuit board there are three yellow circles, there are Philips screws in them spots that need to be removed.  Last you need to remove the battery which has a red square around it and its glued down so it takes a little force to remove it from the back of the screen.

 

Now you can use the pry tool to remove the LED screen apart from the digitizer and WALLA your done.  I know this isn't easy for beginners to use but for beginners that want to try this its fairly easy and a good start.  Goodluck